Motors & Spare Parts

Mechanically sound but the base has been repaired. One of the connecting sockets has broken off but the electrical tag remains so a wire can be attached.
The attached gearbox gives 6 different ratios for a variety of power outputs. A switch controls forward and reverse with a centre off position.
Requires 4-12v dc.
This motor appears in instruction manuals from the 1960's through to the 1990's

4-12v dc.

Pre-war red motor.
Mechanically very good condition, some paint loss through use, tested and works ok, un-boxed
Levers for stop-start and forward-reverse
Supplied with a key

Pre-war nickel period motor.
Very good condition, some plating missing through use, tested and works ok, un-boxed
Levers for stop-start and forward-reverse
Supplied with a key

Pre-war nickel period motor.
Very good condition, some discolouration with age, tested and works ok, boxed
Levers for stop-start and forward-reverse
Supplied with a key

Pre-war blue/gold period motor.
Very good condition, some paint loss through use, tested and works ok, unboxed
Lever for stop-start
Supplied with a key

Very good condition, very slight paint loss through use, discoloured with age, tested and works ok, unboxed
Levers for stop-start and forward-reverse
Supplied with a key

Very good condition, very slight paint loss through use, tested and works ok, boxed
Levers for stop-start and forward-reverse
Supplied with a key

Used but in very good condition. A little discoloured with age but mechanically sound, fitted with new mortor brushes. Will perform best on 20v ac but will run on 12v dc.

Combines powerful motor with a single ratio gearbox to give an output speed of 30rpm at 12v dc. Connects directly to Meccano via a 5x3 hole flat plate. Ideal for larger models. Length 63mm, diameter 32mm.

Similar to Meccano E15R & E20R motors. A modern powerful 12v dc motor is "sandwiched" between two sideplates. With on-off/revesing switch which can be remotely operated with an adaptor (supplied). The final drive via a worm and gear is out of both side plates. The shaft can be substituted with a longer one. Side plates 127mm x 63mm (10x5 holes), width 43mm.

Battery box can be constructed for 3v or 6v output. Also suitable for tri-square parts
Colours may vary subject to availability.

As used for M770 Motor Set or as included in motorised Meccano Sets. Output shaft for standard circular hole or tri-square hole parts. Intended as a replacement for a broken or faulty motor.
Colours may vary subject to availability.

This reduction gearbox bolts directly on to motor M770.

Separate outputs each controlled by a reversing switch for 12v and 4.5v. Designed for use where current consumption is low.