Your cart 0 0.00
First for Meccano

Motors & Spare Parts

12v dc motor with "sideplates"
(Code: ME12R)
106.50
This motor is maximised for powerSimilar to Meccano E15R & E20R motors but runs slower with much more power. A modern powerful 12v dc motor is "sandwiched" between two sideplates. With on-off/revesing switch which can be remotely operated with an adaptor (supplied). The drive from the motor is transmitted through 90 deg via a worm and pinion giving a 25:1 reduction ratio. In this configuration the final drive is reduced but very powerful. This final drive output is then at right angles out of both side plates. This shaft can be substituted with a longer one. Side plates 127mm x 63mm (10x5 holes), width 43mm.
12v dc motor with "sideplates" (slight damage)
(Code: Lot139)
89.99
This motor is maximised for powerSimilar to Meccano E15R & E20R motors but runs slower with much more power. A modern powerful 12v dc motor is "sandwiched" between two sideplates. With on-off/revesing switch which can be remotely operated with an adaptor (supplied). The drive from the motor is transmitted through 90 deg via a worm and pinion giving a 25:1 reduction ratio. In this configuration the final drive is reduced but very powerful. This final drive output is then at right angles out of both side plates. This shaft can be substituted with a longer one. Side plates 127mm x 63mm (10x5 holes), width 43mm.This motor has suffered slight damage in transit. The front plate (with the switch) has split. This has been repaired and is now ok so is offered at a discount.
12v dc Motor/Gearbox
(Code: MEP-S20)
44.99
Combines powerful motor with a single ratio gearbox to give an output speed of 20rpm or 59rpm at 12v dc.
Connects directly to Meccano via a 3x3 hole flat plate. Ideal for models where high power is required.
Length 60mm, diameter 25mm.
The reduced diameter and smaller mounting plate over the MEP Motor allows fitting in more restricted spaces.
12v dc Motor/Gearbox
(Code: MEP)
69.99
Combines a powerful motor with a single ratio gearbox to give an output speed of 18rpm at 12v dc. Connects directly to Meccano via a 5x3 hole flat plate. Ideal for models where high power is required. Length 63mm, diameter 32mm.
12v/4.5v Battery Box
(Code: MBATT1)
5.99
Separate outputs each controlled by a reversing switch for 12v and 4.5v. Designed for use where current consumption is low.
3v Battery Box with Switch
(Code: M720)
4.99
Original Meccano parts as used in sets in the 1990's. Intended for use with Motor M700. Contains Battery Housing, Battery Contacts, Connector and Wire.
Meccano E15R Electric Motor (used) - Boxed
(Code: E15R(B))
49.99
Used but has been cleaned and tested. Supplied in orginal box. Will work on 12-15v AC or DC found on a model railway control unit. Incorporates a reversing switch with centre off.
Meccano E20R Electric Motor (used)
(Code: E20R)
49.99
Used but has been cleaned, tested and paintwork refurbished. Will perform best on 18-20v ac but will run from a model railway control unit on 16v ac or 12v dc.
Meccano E20R Electric Motor (used) - Boxed
(Code: E20R(B))
49.99
Used but has been cleaned, tested and paintwork refurbished. Supplied in original box. Will perform best on 18-20v ac but will run from a model railway control unit on 16v ac or 12v dc.
No.1 Clockwork Motor (used)
(Code: CWK1)
24.99
Very good condition, very slight paint loss through use, tested and works ok, boxed Levers for stop-start and forward-reverse Supplied with a key The picture is illustrates the general condition and may not be of the motor on offer.
No.1 Clockwork Motor (used)
(Code: CWK3)
33.32
Very good condition, some paint loss through use, discoloured with age, tested and works ok, unboxed Levers for stop-start and forward-reverse Supplied with a key The picture is illustrates the general condition and may not be of the motor on offer.